- Brushless Design, No brushes or slip rings to fail.
- No rotating windings, Non-Electrical unitized rotor shaft.
- Large Diameter stator wire. Lower I²R winding loss.
- Cooler stator operation. High amperage output.
- High mechanical to electrical efficiency, saves fuel.
- Replaceable diodes on most models, high load dump capacity, extra large heat sinks.
- Positive, Negative and Isolated ground options
- Available with built-in Electrodyne® 12/24 Start-Charger.
- Integral alternator and bearing housing casting providing permanent bearing alignment & oversize grease reservoir.
- Long-life, heavy-duty bearings, high temperature grease.
|
- Driven-End bearing has a high ISO Basic Dynamic Load Rating.
- Double lip grease seal with Teflon element (600°F rating).
- Unmatched durability and reliability, simplified maintenance and rebuild procedures.
- Lower cost per hour/mile.
- Extended warranty available.
- 12 volts up to 450 amps
- 24 volts up to 250 amps
- 32 volts up to 200 amps
- 48 volts up to 150 amps
- 64 volts up to 100 amps
|
